Beman Centershot and Axis Trad shaft outside diameters ???

[Sapcut]

When searching, i only see the point size but not actual outside diameter sizes.

Anyone have this info handy?  Thanks

[drewsbow]

axis are .262
beman are  .279

[Sapcut]

Thanks.  Is that for all spines or only specific ones ?

[TomMcDonald]

All internal diameter would be the same, external diameter would vary for spines.

[JRY309]

If you are looking for point size,Saunders make 17/64 points for Axis up to 125 grs..PDP used to make points for Axis a 9/32 that tapered down to 17/64 at the base to make a smooth fit on Axis up to a 145 grs..As for Beman Centershot's they use a 9/32 point.

[Sapcut]

Thanks

Im looking for the specific ODs for proper footing sizes.

[olddogrib]

Not to hijack the OP's thread, but since his question got answered, is the ID of the Beman Centershot such that they'll accept the same inserts and nocks as the GT trads and ICS?

[JRY309]

No they won't,the ID of an Axis is .204 that uses a X-nock,the ID of a Beman Centershot is .233 that use a H-nock and the ID of GT and ICS is .246 that use a S-nock or some call a S-type nock.

[drewsbow]

mine are on 500's

[Sapcut]

Thanks Drew

[drewsbow]