Martin Hunter

[bucksakemmer]

I'm shooting a Martin Hunter 45# drawing 29.5 Shooting Axis 500 30in 100 grain insert 100 grain field point brace height at 8 1/4 not at 1/5 .
Have tried several arrow and different brace height and nock set.
I get a shelf noise and rug wear on the outside edge, It sounds like the shaft is slapping the shelf.
Any suggestions would be appreciated.

[Shooty1]

Possible the nock point is too high and the arrow slightly weak?
Maybe try losing some weight up front--a regular insert w/ 125gr points.

[sweet old bill]

put the bow on it side and cover the riser above the rug and then shoot one arrow and see if have drag marks. I think you will find you have to increse your nock point that it is to low, and the brace height is just about right...

[sweet old bill]

fat fingers, need to add put baby powder on the riser so you can see the drag marks...