INFO: Trad Archery for Bowhunters



Author Topic: Canada mints Bear coin  (Read 588 times)

Offline TonyW

  • Moderator
  • Trad Bowhunter
  • ***
  • Posts: 1033
Canada mints Bear coin
« on: September 01, 2008, 01:34:00 PM »


Not a bad price for a coin to put in a bear replica.

Offline PAPALAPIN

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 2642
Re: Canada mints Bear coin
« Reply #1 on: September 01, 2008, 05:05:00 PM »
Neat Tony

Is it about the right size, or would the hole have to be modified.
JACK MILLET-TBG,TGMM Family of the Bow


"Don't worry about tomorrow.  If the sun doesn't come up in the morning, we will play in the dark" - ME

The most important part of your hunting setup is the broadhead.  The rest is just the delivery system.

Offline billy shipp

  • Trad Bowhunter
  • **
  • Posts: 1159
Re: Canada mints Bear coin
« Reply #2 on: September 01, 2008, 05:35:00 PM »
I have a 64 Bear replica built by Mike St Johns....It has a Canadian quarter inlaid, but the $2.00 piece would be cool on the other side too...are they available?

Billy

Offline TonyW

  • Moderator
  • Trad Bowhunter
  • ***
  • Posts: 1033
Re: Canada mints Bear coin
« Reply #3 on: September 01, 2008, 07:00:00 PM »
The complete diameter of the "Toonie" is 28 mm, the outer ring is 99% nickel and the inner coin is 92% copper, 6% aluminum, and 2% nickel.

They have minted these since 1996, so there are millions in circulation.

"Many Toonies in the first shipment of the coins were considered defective, because they could separate if struck hard or frozen, as the centre piece would shrink more than the outside. This problem quickly garnered media attention and eventually was believed to have been corrected, and the initial wave of so-called Toonie popping blew over a few months after the coin's introduction. Although the public appears to believe the Toonies were corrected, the coins can still be separated if struck hard or frozen. Such a separated coin may still be redeemed at a bank for its face value; however, Canada's Currency Act explicitly reads "No person shall ... melt down, break up or use otherwise than as currency any coin that is current and legal tender in Canada."[3] Punishment is a fine of up to $5000.00 and/or up to 5 years."

Offline TonyW

  • Moderator
  • Trad Bowhunter
  • ***
  • Posts: 1033
Re: Canada mints Bear coin
« Reply #4 on: September 01, 2008, 07:04:00 PM »
A bear coin is about 20 mm in diameter, so it sure looks promising.

Offline Novaln1975

  • Trad Bowhunter
  • **
  • Posts: 389
Re: Canada mints Bear coin
« Reply #5 on: September 02, 2008, 12:36:00 PM »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©