Author Topic: i know it was here BUT where????? (Read 286 times)

shaft slinger · « **on:** January 16, 2008, 10:05:00 AM »

an article on making cast antler burrs from resin for limb bolts for take down recurves any body know where it is THANKS

Jerry Jeffer · « **Reply #1 on:** January 16, 2008, 11:00:00 AM »

That post is no longer here. I had it book marked, but when I went to it recently, it said the topic does not exist. Sorry. I do remember that some of the paint on rubber stuff was used on an antler to make the mold. the mold was filled with resin. The the pieces were stained.

Hatrick · « **Reply #2 on:** January 16, 2008, 11:26:00 AM »

shaft, get a copy of the Fall 2007 "Bowyers Journal". There's a good article in there on page 21 by Mike Huston on casting antler burrs for limb bolts.

shaft slinger · « **Reply #3 on:** January 16, 2008, 11:53:00 AM »

thanks all i thank i have a copy of the b/j will look it up

News:

Author Topic: i know it was here BUT where????? (Read 286 times)

shaft slinger

i know it was here BUT where?????

Jerry Jeffer

Re: i know it was here BUT where?????

Hatrick

Re: i know it was here BUT where?????

shaft slinger

Re: i know it was here BUT where?????

Users currently browsing this topic:


LEFT HAND BOWS CLASSIFIEDS	TRAD GANG CLASSIFIEDS ACCESS	RIGHT HAND BOWS CLASSIFIEDS