« previous next »
Pages: [1]   Go Down

Author Topic: Ash backing strips???  (Read 872 times)

Online Lee Lobbestael

  • Trad Bowhunter
  • **
  • Posts: 489
Ash backing strips???
« on: January 19, 2009, 10:54:00 AM »
Hey! I am currently making an ash self bow. I bought the piece of ash from a hardwood dealer and i had them rip an inch off both sides for me so i didn't have so much wood to take off with a draw knife. The pieces that were cut off are about two inches wide and looked like they could be used for backing strips(if they have good tensile strength that is) The grain on these pieces runs at a fourty five degree angle. I appreciate any input!
Logged

Online Pat B

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 15027
Re: Ash backing strips???
« Reply #1 on: January 19, 2009, 11:34:00 AM »
Probably not a backing strip because of the run offs on the strips you have. Ash , with the right grain, would probably make a good backing for some of the lighter whitewoods.
Logged
Make the most of all that comes and the least of all that goes!
TGMM Family of the Bow

Online Lee Lobbestael

  • Trad Bowhunter
  • **
  • Posts: 489
Re: Ash backing strips???
« Reply #2 on: January 20, 2009, 05:56:00 PM »
Thank you I was thinkin the same but just thought I would get a second opinion
Logged

Offline Roy Steele

  • Trad Bowhunter
  • **
  • Posts: 1087
Re: Ash backing strips???
« Reply #3 on: January 29, 2009, 07:03:00 PM »
It is said theres a bow in every tree.
  So take your time and you will be find.
Logged
DEAD IS DEAD NO MATTER HOW FAST YOUR ARROW GETS THERE
 20 YEARS LEARNING 20 YEARS DOING  20 YEARS TEACHING
  CROOKETARROW
Pages: [1]   Go Up
« previous next »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©