Okay the picture finally worked.This is a good way to apply wood to limb bolts that i think really adds to the look of the bow.I first cut 1/8" thick wood that is wide enough to allow for some slippage when epoxied on.After the epoxy has dried i sand the excess off by putting the threaded part of the bolt in my drill press and sand it close while holding my sanding block at an angle.Finally i use a file held at an angle and take of just enough aluminum to form a clean line between the wood an aluminum.This is much easier than trying to sand circles and apply them.
Topic: Applying wood to limb bolts (Read 323 times)
