Author Topic: Set-up to spray Fullerplast, recommendations? (Read 373 times)

myshootinstinks · « **on:** July 08, 2010, 12:03:00 AM »

What spray gun, filters, etc do you fellas recommend? I have a compressor and there is a shop in my near future. Any and all advice appreciated as I've never used two part finishes on bows. Thanks in advance, Doug

Apex Predator · « **Reply #1 on:** July 08, 2010, 05:48:00 AM »

Doug, I use a singe action Pasche air brush with the largest nipple that comes with it. I use a 3-4 oz bottle. I use a little pancake compressor and spray 45 psi. I thin the Fuller with around 1/3 thinner to 2/3 finish. I haven't had good luck with any thinner except what they recommend, and sell at Van Dee. Use a good chemical respirator!

myshootinstinks · « **Reply #2 on:** July 08, 2010, 07:13:00 PM »

Thanks Marty. What is Van Dee, a supplier I presume? Do you have their contact info? Doug

tawmio · « **Reply #3 on:** July 09, 2010, 12:22:00 AM »

www.spraygunworld.com has alot of good deals for spray equipment.
you might pay a bit more but you get better quality.
Tommy

mater · « **Reply #4 on:** July 09, 2010, 10:39:00 AM »

I have used touch up guns and full sized gravety feed spray guns with good results.

Apex Predator · « **Reply #5 on:** July 09, 2010, 11:01:00 AM »

Hopefully you got my PM.

News:

Author Topic: Set-up to spray Fullerplast, recommendations? (Read 373 times)

myshootinstinks

Set-up to spray Fullerplast, recommendations?

Apex Predator

Re: Set-up to spray Fullerplast, recommendations?

myshootinstinks

Re: Set-up to spray Fullerplast, recommendations?

tawmio

Re: Set-up to spray Fullerplast, recommendations?

mater

Re: Set-up to spray Fullerplast, recommendations?

Apex Predator

Re: Set-up to spray Fullerplast, recommendations?

Users currently browsing this topic: