Author Topic: sapwood on osage selfbow  (Read 744 times)

Offline b.glass

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 3098
sapwood on osage selfbow
« on: November 12, 2010, 02:23:00 PM »
I've read about it. I know that sapwood on a yew selfbow is good and that you can strip the bark off a fresh white wood stave and make a selfbow. I have never done either of these. It seems I've read that some sapwood on osage is ok. What is your experience.

The staves I have, have darker sapwood than any others I have seen and it is hard. Below the thick sapwood the rings get quite a bit thinner.

I should post a picture, yes?
B.Glass, aka Mom, aka Longbowwoman
Gregory R. Glass Feb. 14th, 1989-April 1st, 2007; Forever 18.
TGMM Family of The Bow
Mark 5:36 "Don't be afraid, just believe".

Offline Osagetree

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 3512
Re: sapwood on osage selfbow
« Reply #1 on: November 12, 2010, 02:53:00 PM »
Here's a couple osage bows with the mostly white wood left on,,, even a little bark at the handles! These were from limbs though!
 
 
 
>>--TGMM--> Family of the Bow

Online Pat B

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 15027
Re: sapwood on osage selfbow
« Reply #2 on: November 12, 2010, 04:13:00 PM »
Very cool bows, Joe. I love osage sapling(limb) bows!
  Bona, I have made osage bows with all sapwood, 50/50 sap/heart wood, heartwood with a few rings of sapwood and all heartwood. All made good bows. The more sapwood you use the thicker the bow will be.
Make the most of all that comes and the least of all that goes!
TGMM Family of the Bow

Offline George Tsoukalas

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 2922
Re: sapwood on osage selfbow
« Reply #3 on: November 12, 2010, 06:49:00 PM »
NIce bows. The best scenario is take off the sapwood. If there is not enough then get as close to the heartwood as possible as the sapwood will be stronger.  Jawge

Offline Curt Brisky

  • Trad Bowhunter
  • **
  • Posts: 37
Re: sapwood on osage selfbow
« Reply #4 on: November 12, 2010, 11:04:00 PM »
I made a 50" Osage recurve and left a thin layer of sapwood on.  The draw weight is 65@26. It has held together for two years. No sinew just sapwood.  This years sapwood is next years heartwood so Ed Scott says.
Build a kid a bow

Offline Osagetree

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 3512
Re: sapwood on osage selfbow
« Reply #5 on: November 13, 2010, 05:37:00 AM »
Pat you're right, these bows were saplings and not limbs! Sapling sisters as matter of fact.
>>--TGMM--> Family of the Bow

Offline b.glass

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 3098
Re: sapwood on osage selfbow
« Reply #6 on: November 13, 2010, 07:45:00 AM »
I would expect a bow with sapwood to take more set. Dose making them thicker counteract this?

"Very cool bows", were exactly my thoughts Pat!
B.Glass, aka Mom, aka Longbowwoman
Gregory R. Glass Feb. 14th, 1989-April 1st, 2007; Forever 18.
TGMM Family of The Bow
Mark 5:36 "Don't be afraid, just believe".

Offline Osagetree

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 3512
Re: sapwood on osage selfbow
« Reply #7 on: November 13, 2010, 08:15:00 AM »
B.

Though these bows were only in the 45 to 50 lbs range they did not seem to take on anymore set than all heartwood osage bows. I usually make my bows around 62" and these were 66".

Here's a link to the thread done awhile back.
 http://tradgang.com/noncgi/ultimatebb.php?ubb=get_topic;f=125;t=003027;p=1
>>--TGMM--> Family of the Bow

Offline DVSHUNTER

  • Trad Bowhunter
  • **
  • Posts: 2717
Re: sapwood on osage selfbow
« Reply #8 on: November 13, 2010, 08:33:00 AM »
I recently made a bow for a man in TX with thre thin layers of sapwood on it. It pulled 60@29 and was 66ntn. It shot well and took an inch and a half of set. He was pleased. I can't wait to see it once the osage darkens.
"There is a natural mystic flowing through the air; if you listen carefully now you will hear." Bob Marley

Offline John Scifres

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 4540
Re: sapwood on osage selfbow
« Reply #9 on: November 16, 2010, 12:15:00 PM »
Wider, rather than thicker will reduce set.
Take a kid hunting!

TGMM Family of the Bow

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©