Author Topic: Making a drilling jig? (Read 430 times)

Don Armstrong · « **on:** August 10, 2011, 06:43:00 PM »

Going to make a drilling jig for a take down bow. The inserts for the limb bolts have a 1/2"-13 thread and you use a 27/64" drill bit. Is this correct or should I leave more wood for the tap. Thanks, Don

kennym · « **Reply #1 on:** August 10, 2011, 07:21:00 PM »

Don, that is what I used, but so far mine is not accurate nuff to suit me.

SEMO_HUNTER · « **Reply #2 on:** August 10, 2011, 11:35:00 PM »

Don I'd like to get a copy of that limb bolt jig when you get er built if you don't mind. I may end up trying an all wood 3 piece at some point just to say I did it. Got the limb bolt hardware, just need to build the rest to go with it.

Ron Foley · « **Reply #3 on:** August 11, 2011, 11:35:00 AM »

Bingham sells a jig that works well if using one bolt and a blind pin

Don Armstrong · « **Reply #4 on:** August 11, 2011, 08:01:00 PM »

Ron, I looked at that one. Some have said they didn't care for the screws. I have access to a lathe, mill and some free metal, so I can make one for free. Don

kennym · « **Reply #5 on:** August 11, 2011, 09:33:00 PM »

The screws were fine on mine, the 1/4" hole that was off to one side by .020" was what killed it for me!

News:

Author Topic: Making a drilling jig? (Read 430 times)

Don Armstrong

Making a drilling jig?

kennym

Re: Making a drilling jig?

SEMO_HUNTER

Re: Making a drilling jig?

Ron Foley

Re: Making a drilling jig?

Don Armstrong

Re: Making a drilling jig?

kennym

Re: Making a drilling jig?

Users currently browsing this topic: