Riser question

[Bradford]

So I got this riser just about shaped up.  I am a little disapointed in the cut out area below the handle where my stripes ran thru.  I wanted to see some accent stripes on the back of the limb pad areas:

 

But not so happy with the straight lines it is making on the curved area below:

 

Around the throat does not bother me.. looks like a diagram "put thumb and fore finger here"..LOL..

Any ideas on how to dress this up.. or is it was it is?

Thanks

[Crooked Stic]

Just have to make the thicker on the next time.

[rmorris]

I think I looks good. As you know you can radius that flat face to some curves in the red lines, or.... You can pull a Ralph ( unhappy with the look of a riser so you cut it way down and build it back up in layers)