Limb wedges

[3point or better]

What determines the thickness of the wedges in take down limbs also what determines the length of the wedge

[JamesV]

It would have to be the design of the bow. Of the dozen or so take down re-curve bows I have built, I always had the specs. for the wedges for each design.

James

[kennym]

The wedge has to be past the riser enuff to bend a little to relieve stress at riser end. I also use a power lam too. I dislike bows that have a noticeable hinge at riser(or wedge ) end. Should be much more durable too.

I use a .300" x 8.25" strait wedge (no flat for bolt)on my TD longbow . I know guys who go .250" but I haven't ventured that thin yet.

"Usually" the wedge is 4" past riser end. Hope that helps....

'thickness of the wedges'--- enuff to not bend on riser portion

'length of the wedge'-- long enuff to make the limb bend the way you want

[Wolftrail]

Originally posted by kennym:

I use a .300" x 8.25" strait wedge (no flat for bolt)on my TD longbow . I know guys who go .250" but I haven't ventured that thin yet.
 

You mention (no flat for bolt) is it better that way.  I have made a few and prefer the flat when aligning the limbs for drilling.  I am new to this so I drill thru the limb and into the riser at the same time.

[kennym]

No it's not better that way, I just like the smoother limb profile look....   :cool:

[beachbowhunter]

Kenny, I use .25 for the wedge thickness. I also us a PL so the net thickness is probably around .300 like you mention.  I don't like fat wedges, or tips!

[Mad Max]

I would say limb pad angle and reflex or deflex
My limb pad angle is 7.5 degrees and over hang is 3 1/2" .036 per inch taper 6 1/2" long

[Wolftrail]

Originally posted by kennym:
No it's not better that way, I just like the smoother limb profile look....    :cool:  

Thanks for the answer always wondered about that.

[Wolftrail]

Originally posted by Mark Daniel:
I would say limb pad angle and reflex or deflex
My limb pad angle is 7.5 degrees and over hang is 3 1/2" .036 per inch taper 6 1/2" long

I have only built a couple I go 7.0 degrees. Using a subtle reflex on the tips.

Sorry 3point did not mean to hijack this thread.....   :rolleyes:

[T Folts]

I use .250 flat on top and 8.25" long. If you go to thick the wege will not flex that much causing the intended working part to be non working.