Author Topic: Alignment pin (Read 1550 times)

Wolftrail · « **on:** March 09, 2019, 06:57:57 PM »

I have a few alignment pins coming loose on the my take downs. I'm using JB weld. What glue are you using for the pin.

jess stuart · « **Reply #1 on:** March 09, 2019, 07:41:05 PM »

I use epoxy but, file a small groove in the pin to give the epoxy something to hang on to. Sometimes the wood in your wedge will take on moisture and swell gripping the pin very tightly. Periodic wax on the pins is a good practice too.

kennym · « **Reply #2 on:** March 09, 2019, 08:03:27 PM »

I’m with Jess !

skeaterbait · « **Reply #3 on:** March 09, 2019, 08:23:00 PM »

I'm with Kenny

Crooked Stic · « **Reply #4 on:** March 09, 2019, 10:46:15 PM »

I am with Jess and Kenny.

I take a Q tip and apply petroleum jelly to the pin holes in the wedges. Lubes them and turns moisture away.

buddyb · « **Reply #5 on:** March 09, 2019, 11:16:32 PM »

I use MT-13 Epoxy and apply a little string wax to the pin holes.

Wolftrail · « **Reply #6 on:** March 10, 2019, 12:07:43 PM »

Thx guys.

T Folts · « **Reply #7 on:** March 28, 2019, 11:50:23 AM »

I also clean them with acetone to remove any oil on them.

News:

Author Topic: Alignment pin (Read 1550 times)

Wolftrail

Alignment pin

jess stuart

Re: Alignment pin

kennym

Re: Alignment pin

skeaterbait

Re: Alignment pin

Crooked Stic

Re: Alignment pin

buddyb

Re: Alignment pin

Wolftrail

Re: Alignment pin

T Folts

Re: Alignment pin

Users currently browsing this topic: