I ask because I have some Doug Fir shafts and one Larch shaft, that are too short for me. If your buddies call you short draw, these might be for you.
3 are 27 1/8"
2 are 27 7/8
2 are 28 1/4
I believe they are all less than 23/64" I did not check the spine on them, but would guess it's in the 55-60# range. I usually just sand them till I get the spine I need.
They currently weigh around 400grains each, give or take 20grains. Should have some thumping power!
If you can use these, P.M. me and they are yours.
Guess which one is the Larch