Band saw blade

[monterey]

I have a 10" abrasive wheel that works nicely on a table saw.   It might work on G10?? 

Anymore I rough limbs out on the Rigid oscillating belt with 36 grit and do the final by hand.

[Autumnarcher]

I use a 6 tpi x.025 bi-metal blade for cutting out risers, resaw, and cutting out the sight window. I did notice the glass does dull it a lil bit. I have not cut limbs down with it, I was worried about the glass chipping or peeling on the bottom side of the cut. Am I ok to rough out limbs with one. Ive been grinding them down with belt sander and a 36 grit belt.

[buckeyebowhunter]

You can rough them with the bandsaw but honestly I prefer to use the belt sander with 36 grit like you say you've been doing. I feel like I'm just as accurate with the sander and also saves on the blade some.

[BO-R]

Buckeyebowhunter...try Spectrum supply much better price on trimaster blade.

[beachbowhunter]

I have a 10" abrasive wheel that works nicely on a table saw.   It might work on G10?? 

Anymore I rough limbs out on the Rigid oscillating belt with 36 grit and do the final by hand.

same here..

[kennym]

I have a 10" abrasive wheel that works nicely on a table saw.   It might work on G10?? 

Anymore I rough limbs out on the Rigid oscillating belt with 36 grit and do the final by hand.

same here..

Same here but I use an ancient disc sander . Use good dust collection , glass dust is no good!! And check to see you aren’t getting the limb hot, the disc doesn’t seem to get it as hot as my edge sander...

[Overspined]

I use a carbide Dedicated band saw for cutting anything that’s not wood...works great.