Sanding belts

[Buemaker]

I am looking for sanding belts for metal in size 4x48 inches, fine grit. I can’t find much over here. Does anybody know where to find? Thanks.

[wood carver 2]

I did a search on the sites where I buy abrasives from and I can’t find any belts that are 4” by 48”. All the 48” belts seem to be 6” wide.
Dave.

[kennym]

https://www.trick-tools.com/4_x_48_40_grit_3M_Aluminum_Oxide_Belt_BLT48440_S_530

Didn't check shipping,

The big auction site may have some too....

[wood carver 2]

I guess I didn’t look far enough. Thanks Kenny. I bookmarked the site. You can’t have too many suppliers.
Dave.

[Mad Max]

Supergrit does NOT have them.
Looks like kennym found them

[Eric Krewson]

Rather than AO I would go with these, they are worth the extra money.
https://www.amazon.com/Metal-Grinding-Zirconia-Sanding-Belts/dp/B00DH0CVW0

[kennym]

The zirc belts do last much longer.

[Buemaker]

Thank you, I’m grinding along.

[Crooked Stic]

I got a box full of 4x36 belts they marked 320 but I think they are 40 or 50 grit. anybody wants them for shipping cost.

[Shredd]

Yeah... From what I understand you want Zirc for metal... If you can find 6"x48" over there it is easy enough to just rip 2" off...  I do it all the time on my 48" sander... I rip off about 1/2 to 3/4" off the belt so when it wanders it doesn't mess with my rub collar...

[Kauz]

Being in Europe you might try the following link, where you can customize belts to your own measurements:
https://www.schleifmittel-ab-werk.de/