Author Topic: Concave limb pad.  (Read 1148 times)

Offline Buemaker

  • Trad Bowhunter
  • **
  • Posts: 3116
Concave limb pad.
« on: December 26, 2020, 09:21:28 AM »
If you should make a riser with a concave limb pad like Asbell’s Bighorn recurve, how would you make a drilling jig for riser and limbs. I can’t figure it out. In drawing curve is tighter than it will be in a riser.

Online Mad Max

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 6565
Re: Concave limb pad.
« Reply #1 on: December 26, 2020, 09:44:30 AM »
Top concave to drill limbs.
Bottom side for riser
Center hole would need to be 5/16" and then enlarge the holes later or have 2 jigs



I never made this, just a drawing, 2 jigs
I was going to use 2 flat head screws or 1 normal hardware for T/D
Dowels need to be parallel
I would rather fail at something above my means, than to succeed at something  beneath my means  
}}}}===============>>

Online Mad Max

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 6565
Re: Concave limb pad.
« Reply #2 on: December 26, 2020, 09:49:37 AM »
It would not be perfect.
You could make it if you scratch you head enough  :laughing:


Here is a pic. of mine
I would rather fail at something above my means, than to succeed at something  beneath my means  
}}}}===============>>

Online Crooked Stic

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 6075
Re: Concave limb pad.
« Reply #3 on: December 26, 2020, 10:05:56 AM »
As long as you keep the line on each side of the bolt hole and same distance each way. You can drill all from one side keeping the same side down.
High on Archery.

Online kennym

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 17339
Re: Concave limb pad.
« Reply #4 on: December 29, 2020, 05:11:44 PM »
Hmmmmm.....  Has anyone ever used a bolt and a slot in limb and riser with a steel piece cut off a thick washer kinda like the biscuit joining technique in furniture?  Only one hole to drill that way... :goldtooth:
Stay sharp, Kenny.

   https://www.kennysarchery.com/

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©