Current status of bear paw glass

[pditto613]

A search of bear paw clear glass shows it comes in light and then heavy compared to Gordon’s glass. What is the current take on on the outcome of a bear paw bow.  Have to make a light weight and plan on using .030 clear bear paw

[kennym]

Bear Paw  .040 has been up and down on weight. Right now my spine tester shows same as Gordons, I don't keep .030 so can't really say on it, but depending on which roll it comes from, if it's like the .040 it will vary. Sorry  can't be more help...

[mmattockx]

Right now my spine tester shows same as Gordons

Is your glass spine test the same as an arrow spine test? Support the test piece in two places and put a load in between the supports? How accurate have you found it for adjusting the stack to suit a new batch of glass?


Mark

[kennym]

I tried a spine tester like you mention that I made for wood arrows but 26" is just too much span. I just screwed a block to the side of my glass cut table, and use a spring clamp on 8" of glass past the block with another block clamped on top of glass.  I used Gordons as a standard bend with the weight with marks for different sizes on side of table since Gordons is  usually pretty close .  The test seems to be pretty close to what to expect.

[pditto613]

Thanks Kenny

[mmattockx]

I tried a spine tester like you mention that I made for wood arrows but 26" is just too much span. I just screwed a block to the side of my glass cut table, and use a spring clamp on 8" of glass past the block with another block clamped on top of glass.  I used Gordons as a standard bend with the weight with marks for different sizes on side of table since Gordons is  usually pretty close .  The test seems to be pretty close to what to expect.

Thanks for the details, I will have to keep that in mind if I start mixing and matching my fibreglass pieces.


Mark