« previous next »
Pages: [1]   Go Down

Author Topic: Bandsaw circle jig  (Read 1063 times)

Offline Meleon

  • Trad Bowhunter
  • **
  • Posts: 43
Bandsaw circle jig
« on: November 13, 2021, 07:27:16 PM »
Anybody have any pictures of a simple bandsaw circle jig they like to share? I want to add some spice to my riser.
The simpler the better.
Logged

Online kennym

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 17339
Re: Bandsaw circle jig
« Reply #1 on: November 13, 2021, 09:00:43 PM »
Check this out and see if it helps...




https://www.kennysarchery.com/bow-build
Logged
Stay sharp, Kenny.

   https://www.kennysarchery.com/

Offline Appalachian Hillbilly

  • Trad Bowhunter
  • **
  • Posts: 661
Re: Bandsaw circle jig
« Reply #2 on: November 13, 2021, 09:09:25 PM »
Kenny, with that radius jig, do you still contour sand after sawing or is it clean enough?
Logged

Online OldRawhide42

  • Trad Bowhunter
  • **
  • Posts: 240
Re: Bandsaw circle jig
« Reply #3 on: November 13, 2021, 09:52:51 PM »
I use a jig like Kennys . I cut a 2x4 with the same radius and use that as a sanding block.
Logged

Online Mad Max

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 6565
Re: Bandsaw circle jig
« Reply #4 on: November 14, 2021, 06:53:36 AM »
Quote from: kennym on November 13, 2021, 09:00:43 PM
Check this out and see if it helps...




https://www.kennysarchery.com/bow-build

Really nice setup Kenny
I like wax paper for my riser blocks :thumbsup:
Logged
I would rather fail at something above my means, than to succeed at something  beneath my means  
}}}}===============>>

Offline Meleon

  • Trad Bowhunter
  • **
  • Posts: 43
Re: Bandsaw circle jig
« Reply #5 on: November 14, 2021, 03:13:49 PM »
Had a bit of a hiccup on the maple riser but the walnut one turned out good so far.
Pretty sure I can fix the maple one with patience.
I copied you swing jig Kenny.

Logged

Shredd

  • Guest
Re: Bandsaw circle jig
« Reply #6 on: November 14, 2021, 03:51:46 PM »
   Nice...  I like that type of accent...
Logged

Offline Meleon

  • Trad Bowhunter
  • **
  • Posts: 43
Re: Bandsaw circle jig
« Reply #7 on: November 14, 2021, 04:23:13 PM »
Thanks! It was nerve racking cutting into that walnut. That piece cost as much as a spruce 2x6
Logged
Pages: [1]   Go Up
« previous next »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©