Warf bow ?

[MCNSC]

Ok , so I just picked up a Hoyt Spectra riser to Warf. Was watching some videos and it seems the plates are just held in by the limb bolt screw. Is that correct? I always thought they were either glued , screwed or otherwise fixed to the riser. I’m thinking I may epoxy the plates in place. Or is that even needed.

[jess stuart]

I set my plates in place with the 24 hour jb welded.  Mounted the limbs and braced the bow with the jb weld still wet in case I needed to adjust alignment.  Worked just fine.  Made a nice shooting bow.