I sanded 2 lams on my .005/.002 sled, It's .005 coming out of the fades and changes to .002 to the tip.
![](https://i.imgur.com/u9IUUF6.jpg)
.
I sanded all the epoxy off all the sides and cut it in half.
Resaw and milled them to .050
![](https://i.imgur.com/vAMyMp3.jpg)
Also Resaw and mill the strip to .037
![](https://i.imgur.com/2owdQXQ.jpg)
I put some Tape on the riser blocks and double side tape them down.
![](https://i.imgur.com/eouR0Tw.jpg)
This double side tape It's .003 thick and works really good, The tape is for holding Insulation to metal buildings.
Put it down and peel of the protector. The template is taped to the riser block so I can fold it over on the tape carefully.
![](https://i.imgur.com/4xeMYqt.jpg)
Off to the band saw to cut between the lines and Pattern sand them.