So I’m finishing up a set of arrows, I just put the last dip of spar urethane on so I could let then sit over night and fletch them up tomorrow night. I have them hanging in my basement (low humidity, good ventilation) from clothes pins. I went down a few minutes ago to find two of the freshly dipped shafts lying on the floor. The clothes pin must of not had a good grip on them, but now I have two sticky shafts that are covered in all the crap thats on my floor (dog hair and such). So what can I do to clean them up? Just wait until there are dry and then hit them with steel wool? They are my best looking set so far and I hate to have two of them are look like a garbage can.