So I did a stupid thing. I normally glue up my carbon inserts with goat tuff or gorilla glue, but decided to try an epoxy this time instead. After I epoxied all the inserts in I set them on the insert to set up for 24 hours. When I came back the next day I had apparently put in a little too much epoxy and it had run down the inside of the insert, and is now preventing me from screwing in any heads.
I was hoping that someone on here might have a nice little trick or idea to remove the epoxy from the inside of the threads. I tried using a small drill bit, and then heating up the threads on a steel adapter to try and heat the epoxy out of there, but to no avail.
Any ideas.