I can't really shoot a whole lot right now on account of my elbow, so I wanted to get my carbons finished.
Here goes; I just bought the long 100gr. brass adapters for my Beman ICS Bowhunter shafts to get more weight up front and use the same weight BH's and field points, but they do not fit snugly. Also the threads go all the way to the top so there is no room for a normal head of any kind to fit in them because on a normal head there is the part that extends from the top of the shaft, the solid part that goes down in the insert and then the threads.
My question is; Would I just use a lot of glue to set the inserts in right and put them down deeper in the shaft? If I don't put them deeper in then there will be the solid part of the head or field point sticking out above the tip of the shaft, because the insert is threaded at the same diameter all the way to the top...
Bakes