What happened to "Single bevel and 3D target" post

[amicus]

I was really looking forward to coming in this morning and reading about Terrys expereince with his Grizzly bh and 3D target. What happened? Why was it deleted?

Gilbert

[Oregon Okie]

I asked him to pull it because it went all haywire. Don't think it was pulled because I asked but because it did.
The consensus was... seems like it wouldn't mess it up if you were careful pulling it out just like any other broadhead beats up a target (two blade).
Terry might report but about his testing he said he could pull them straight out but it was slightly easier if he gave some left pressure. He estimated about 1/16 turn I think. Terry can correct me if I am remembering wrong.

[Charlie Lamb]

I took it away at the request of Oregon Okie. His thread, his decision.
 

[Terry Green]

Here's was my posting....

OK...I just got through shooting an El Grande into my targets and I was able to pull them straight out. And yes, I applied a little left pressure the next shot and they did come out a little easier. I did this 3 times each in both the 3-d and latex targets. They might have moved a 16th of an inch as when I pulled them straight out, it barely scuffed the target surface.

Like I said, I never doubted that the didn't twist to some degree in the target....but not enough for me to ever notice unless I took notice like I did today when I applied left pressure. I sure didn't count turns.

Another fellow went out and tested his Grizzlys, and had about the same results.  He posted right after me.

Now I'm going to lock this on so it don't go haywire.