Hello All,
I was contacted last night and also this morning by a few of you who had already begun to use the new calculator version. It seems like there was a problem with the total weight compensation with shafts that were approaching the extremes of both light and heavy spines. I spent most of the afternoon pouring through the equations and sure enough, I "fat fingered" the numbers in the weigh correlation formula. I hate when I make these stupid little mistakes!
I totally apologize for the error and any confusion it has caused on your guys end. Please delete the 6/11/09 file and use the 6/12/09 version that is being uploaded to the same sites posted above. You can also send me your email address and I will send it directly to you if that is easier.
I have checked it thoroughly for all shaft spine ranges this time and I trust you will find the compensation to be accurate and a improvement over the March release.
Sorry once again and a big thank you to those who pointed it out and helped with the solution.
-Stu Miller