I use a torch that can stand up. When I squeeze the trigger it lights, and when I let go it shuts off. Torch was bought at Home Depot, and is common for plumbing repairs. I heat up my glue, and then apply the glue to the arrow. Once all of the arrows have glue on them, I move onto my points. I grab the point with pliers then heat it up, and then grab the arrow and insert it into the point/broadhead. Once I have the point where I want it (still holding with pliers, I dunk it in a bucket of water to cool the head, and allow it to stay on. Do a spin test, and if need be, reheat to adjust the point alignment. There you go, and with only 2 hands.