wood arrow ???

[flyfish1]

You guys who use woodies what have you found to be the best adhesive for gluing on field points/broadheads?

[Pepper]

Hot melt.
Preparation and proper application, and it is one of the strongest, and the point can be removed, readjusted and aligned with little difficulty.

[Rosco1]

Honestly, I use Gorilla glue and have never had a problem.

[Shedrock]

Originally posted by Pepper:
Hot melt.
Preparation and proper application, and it is one of the strongest, and the point can be removed, readjusted and aligned with little difficulty.

Yup, Ferr-L-Tite.

[SELFBOW19953]

Ferr-L-Tite.  For best results, dunk the point in water while it's still hot.

[smilinicon]

Be sure to clean off any rust-inhibitor from new points before gluing.

[jamesh76]

Ferr-l-tite

I have been experimenting with the Ferr-l-tite low temp (blue) and have had good luck with it so far.

[Grey Taylor]

30 minute epoxy.
Easy to use, easy to adjust the point without having to heat it or burn my fingers, easy to remove to change heads.
Best of all, I simply do not lose points in the targets... ever.

Guy

[Javi]

Low temp hot melt...

[Mike Vines]

Originally posted by SELFBOW19953:
Ferr-L-Tite.  For best results, dunk the point in water while it's still hot.

Exactly.  I use a propane torch to heat the glue and smear it on the tip of the arrow, then heat the point with a propane torch stick on arrow get situated then a quick quench in water to set the head in place.

[Zradix]

I've had problems with Ferr-L-tite in cold weather.
It gets to hard and brittle in the cold.

Now I use an industrial glue stick.

The glue stick stays softer and adheres better than the ferr-l-tite in most temps ESPECIALLY in the cold.

I've done testing on it..freezer and all.

The glue stick melts at a lower temp. I've heard of it softening too much for some in really hot temps.

[Shawn Rackley]

do yourself a favor just use gorilla glue super glue. i went through a million points using everything else hotmelt etc. have not lost a point since swithching to the super glue. u can get it at the mart store in hardware by the rest of the glues. cheap and it works

[snakebite]

Ferr-L-Tite.

[b44mag]

x3 on the gorilla super glue
so far so good

[Arwin]

Ferr-L-Tite    

[Flying Dutchman]

24 hours two components epoxy

[T Lail]

hot melt all the way......  

[Don Stokes]

I'm sure glad I don't live where it's too cold for Ferr-L-Tite! It's all I use, and I "third" the cold water dunk when the point is set but still hot.

[CaptainJ]

I clean out the inside of the point with a .38cal stainless brush mounted in a drill, then use Ferr-l-tite hot glue. Works well and I can change or adjust easily.

CJ

[Jack Denbow]

I have been using Ferr-L-Tite for more than 50 years I guess I will stick (pun intended) with it.
Jack