What size aluminum...

..has an internal diameter of 11/32" to foot a cedar shaft that size?

[SCATTERSHOT]

Maybe this will help...  

[ronp]

So mathematically, it looks like a 2413 or 2415 would work.

[SCATTERSHOT]

Yep. 2413 is what I think I used, but it's been awhile.

Thanks for doing the math fellas.
Susan

[lpcjon2]

Eugene , Rob D. posted that chart in the "How To" section for future use.Tim

[SCATTERSHOT]

Great, I can't remember where I found it, but I'm glad it will be used.

[ronp]

Susan,
The 2413 would provide a slightly looser fit.  Conversely, the 2415s would be a lillte more snug.  Maybe too snug.  You could always sand them down a little.

I'm going to have to experiment-- a couple of coats of poly might make one fit better than the other-- according to my calculations, 11/32"= .34375, 2415+.3450 might be just right....

[ronp]

Your calculations look perfect.  I have been footing carbon shafts and the outside diameters of similar shafts vary depending on the finish (3555 GTs - camo vs wood grain, for example).

[eflanders]

Folks you can now get pre-cut footings from  www.flemishtraditionalsports.com   We call them the FTS Shaft Savers.