Broadhead Buckle

[Longbow1415]

Hi,

Looking for advice and guidance for turning something like this....

 

into something like this....

 

Was thinking of using a Dremel. Any suggestions of what bit to use, and of how to get the surface behind the broadhead so smooth?

Any help would be much appreciated!

Many Thanks  

[longbowray]

I use the small round bit , for wood  . I did the same thing , will try to get a pic of it .

[Bladepeek]

If I'm trying to flatten something like that, or the mortise for a hidden tang knife, I wish for a mill, but then chuck a square ended Dremel carbide cutter in my drill press. Put the piece to be ground in a drill press vise and run the piece back and forth, deepening the cut a few 100's each pass. Slow, but does wonders for my shaky hands.

[GrayRhino]

Neat idea, but don't try to wear it through an airport.  You'll be donating your hard work to a friendly TSA agent.

[Bldtrailer]

Be very carefull running/going (after afew beers)  :mad:   to the mens room you might get cut/or cut off    if you're    in a hurry!