Is the inside of the point tapered or parallel? Looks like that one may be tapered. If so, you'll need a tapering jig. Will need one for the nock end as well. The taper is 5 degrees for the point end and 11 degrees for the nock end. Most trad vendors sell hand held "pencil sharpener" type tapering jigs. However, I believe most only go down to 5/16 in diameter. If so, and if your shafts are 1/4 inch, can wrap some masking tape around them to get them to 5/16 where they fit into the jig.
Or, if you have a table saw or disc sander, can make your own taper boards and grind the tapers with power equipment. There are a number of tutorials in the how to section.