Glue on field point not fitting right

[Scott E]

The points are going on almost all the way but the wont go on completely. I tried it on some POC shafts too below is a hard wood shaft.

 

[Frank V]

I've had the same thing happen.
   I think your taper is too long & bottoming out on your field point before it's fully seated. When I shortened my taper they started fitting properly
Try cutting 1/4" off your point taper.

[LostNation_Larry]

What taper tool?  If you are using a sanding disk and a block the angle could be incorrect.

[Biathlonman]

Some 125s do that, like mentioned above, shorten your taper...just nip 1/4" off and try again.

[Jack Guard]

All you have to do is cut the 1/4" off the tip.  thats it.

[Scott E]

Okay great thanks all. I'm using the traditional only pocket taper tool

[Gil]

Looks to me like the shaft diameter is larger than the point diameter(outside)

[snag]

There are two types of points out there. One is a deep inside tapered point and other has a shallower inside taper.  I'd cut off a little and retry the fit.