Another arrow holder thread(How TO)

[hart2hart]

Thought I'd throw this homemade holder in the mix
after I found a source for material.
Mods move to How to forum if needed.
I made mine out of a 3/4"W by 4"L THICK rubber band found at a garage sale.It will make 2 holders
if you cut it into 2 equal pieces.
I took one piece and rounded the corners just for asthetics.On one end,I took a short piece of scrap aluminum shaft (one size smaller than my hunting shafts) and with a hammer punched a hole about 2 shaft widths in.
Then take scissors or knife and open the hole towards the end.That holds the arrow for you.
I attached the other end to my riser with velcro after inserting my arrow and getting the velcro positoned properly.It would also work great with another hole around a berger button.How you attach it depends on you.
I debated about submitting this til now because I hav not seen any other rubber bands like these except at our Tr...Supply in equine section but they were LONG and $19 to boot.
BUT,stumbling around in a catch-all drawer the other day,I found out I wasn't using a rubber band..I was using a vacum cleaner belt which cost much less and available nearly anywhere..
I wouldn't suggest the one on the wife's vac unless you have a back up.
Works great..silent..cheap..
Sorry I have no camera but it looks like all the rubber armed ones.
Hope this help the frozen index finger crew,it sure did mine.
Mike

Sure wish you had a camera! I am not quite getting the picture?

Bisch

[Stickbow]

Originally posted by Bisch:
Sure wish you had a camera! I am not quite getting the picture?

Bisch

Vey punny....

[katman]

Sounds good, need a pic Mike.

[PowDuck]

     not sure I understand exactly either.

[hart2hart]

I'll try,gents.Might have to email them though.
Thanks,Mike

[Mudd]

Here are a couple I made.

I tie mine on since there's no way I'd put any sticky tape on my beauties...lol

 

 

[hart2hart]

I am emailing pictures if your email is available.
If someone could post,I'd appreciate it.

Thanks,Mike

[iohkus]

Think he's talking about a holder for a nocked arrow.  Like an "Arrow Jack".

[monterey]

Hey Mudd, I'm getting some leather scraps together to make a few of those arrow holders but am not sure how to do the lower shaft holder.  Can't quite make yours out in the pics.  How'd you do yours?

[Mudd]

I used one of those rubber finger separators that I had taken out of a tab.

I heated an old aluminum shaft and burned/melted through where the arrow would rest/be held,then cut away the rubber so the arrow could slide in.

The back side has two rubber wings that held it in the tab, I burned a hole in each wing to run my leather thong through.

Worked better than I had hoped.

God bless,Mudd

[Stumpkiller]

1/2 of a Selway PiggyBacker with a hole drilled through it for a lace and a leather broadhead sheath.  I have these on several of my bows.  Good for stalking (with another quiver for extra arrows - like if you want to loan one to a less efficient bowhunter) or as fast follow up shot should it be needed, or possible, from a stand.

   

   

   

[hart2hart]

Thanks Mudd for the help.
I'm "burning holes" like you in many things..like ethafoam to store my arrows proper..at least the pretty ones.
That smoke can't be great for the lungs,I'm betting.
Mike

[Mudd]