Hot melt... Loosing point question

[stickhorse]

I use a 243cal bore brush to rough up inside, then dip in acetone( only 1 inch ) and wipe out with Q-Tip. drop inserts in acetone, wipe dry, use Quick stick from Big Jim ( same as TJ's post above ) Keep them pushed in as they cool.
Have shoot lots of stumps and a few rocks, never lost a insert.

[**DONOTDELETE**]

Degrease the points and use epoxy on field tips... end of problem....

on broadheads using hot melt sand the inside with 120 grit and twist the point on slowly as you insert the shaft....Then reheat evenly using a heat gun or hair drier and adjust it.