How to modify a split tab for three under ?

[Brianlocal3]

As the title says, how have yall gone about modifying a split tab to three under?

I ask because I have two AWSOME saunders tabs but have gone back to three under and shooting these split tabs is getting my ring finger hit.

I have a Saunders three under tab comming so it will be solved but I'd love to figure out how to utilize my two exsisting tabs for backups.

I appreciate all help and suggestions

DEFENSOR FORTIS
Brian

[Pat B]

Duct tape!     :D

[Brianlocal3]

Pat,
I thought about it

[The Whittler]

Why would you have to fix anything just use them as is it should not make a difference.

[woodchucker]

I was thinking the same as Whittler.....

I have used Can'tPinch tabs for years... I just take out the rubber finger spacer!!!

[Fritz]

I have always shot split fingered tabs three under. No issues for me.

[Brianlocal3]

My issue is that the middle finger winds up over the split slot, so it's string against bare finger, it's getting tore up.
No issue shooting split only 3 under. I was hoping I wouldn't have an issue but I do

[huskyarcher]

I shoot a split finger kantpinch 3 under, no problems at all!

[katman]

For back ups duct tape sounds good.

Between duct tape and WD40 your good to go for most things.    

[Green]

Flip Flop.    

[Brianlocal3]

I don't want to hear it Flap Jack!!!!!

And don't forget bailing/mechanics wire, those three items build rocket ships

[GreyGoose]

I might try using it as a pattern to cut a new tab - just leave out the split.

[Brianlocal3]

My work boots have finally given up the ghost so I may do that

I have a couple of friends that used the split finger Pak-Tab and shoot three under. What they did was just make a solid leather piece to back the brown piece with the finger loop.

Bisch

[Brianlocal3]

Thanks Bisch. I'll try That and remove one of my layers to keep the same feel

[Bjorn]

Basically remove the spacer and lay down the leather to close the gap. It will depend on what make of tab as to how well this will work.

[jess stuart]

I have good luck with the Saunders Fab Tab I just removed the finger separator and shoot.  I fortunately haven't had any issues with the split in the tab.

[savage1]

Not a mod like you asked for but I used to buy lefty tabs and shoot them upside down.
It works quite well.
Now I make my own.

Lou

[Roadkill]

Carefully cut down the split, an inch or so, remove a little leather from the sides so the wedge is cut out, and stitch it up to the point where it contacts the string.  You now have a super flexible tab. You might be able to trim a little off the top and bottom for a more exact fit